| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A flaw has been found in WAVLINK WL-WN530HG4B M_V260724. This impacts the function port_forward of the file /cgi-bin/wapi.cgi. This manipulation of the argument Name causes os command injection. It is possible to initiate the attack remotely. The exploit has been published and may be used. The vendor was contacted early about this disclosure. |
| A vulnerability was detected in WAVLINK WN579X3-D V250402. This affects the function port_forward of the file /cgi-bin/wapi.cgi. The manipulation of the argument Name results in os command injection. The attack may be performed from remote. The exploit is now public and may be used. The vendor was contacted early about this disclosure. |
| A security vulnerability has been detected in WAVLINK WL-WN579A3-A 2026-03-10-94f93d4. The impacted element is the function set_wzdgwMesh of the file /cgi-bin/adm.cgi of the component Initial Setup Wizard. The manipulation of the argument wlan_ssid leads to os command injection. The attack is possible to be carried out remotely. The exploit has been disclosed publicly and may be used. The vendor was contacted early about this disclosure. |
| A flaw was found in Wildfly. A remote unauthenticated attacker can trigger OutOfMemoryError as CSIv2Util's GSS token decoder reads an attacker-controlled length field without bounds checking and attempts to allocate a byte array of that size. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: imx: fix slab corruption from undersized DMA bounce buffers
Since commit faa8e404ad8e ("spi: imx: support dynamic burst length for
ECSPI DMA mode"), the driver allocates its private DMA TX/RX buffers
with kzalloc(dma_len), where dma_len is only rounded up to 4 bytes, but
maps, syncs and unmaps them with DMA_CACHE_ALIGNED_LEN(dma_len), i.e.
rounded up to the cache line size. As a result, the DMA API operates on
memory beyond the end of the allocation.
This was observed on a custom i.MX8MP platform with an mcp251xfd CAN
controller under heavy RPMSG load, as a series of refcount_t warnings
triggered from rpmsg_recv_done() in virtio_rpmsg_bus:
refcount_t: addition on 0; use-after-free.
refcount_t: underflow; use-after-free.
refcount_t: saturated; leaking memory.
Leading finally to an "Unable to handle kernel paging request" oops.
Reproducing this problem took between 30 minutes and roughly 30 hours
under the same workload.
Hardware watchpoints on the refcount of a struct rpmsg_endpoint showed
it was overwritten from 2 to 1 by __pi_memcpy_generic() in the
irq/155-spi2.0 thread. Additionally it was found that a "normal"
rpmsg_recv_done() took 11µs +/-2µs from its kref_get to kref_put. In
the error case the same sequence took about 215µs +/-10µs. Based on
this, an LLM was used to identify the size mismatch fixed here.
Allocate the buffers with DMA_CACHE_ALIGNED_LEN(dma_len) so they cover
the full mapped length, and use the same length for
dma_sync_single_for_cpu() to stay consistent with map and unmap.
With this patch applied, the same workload ran for more than 200 hours
without the problem reproducing. |
| GNU mtools before 4.0.50 has an out-of-bounds write in parse_vses in vfat.c. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Special Elements used in an OS Command ('OS Command Injection') vulnerability. A low privileged attacker with remote access could potentially exploit this vulnerability, leading to Command execution. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Special Elements used in an OS Command ('OS Command Injection') vulnerability. A high privileged attacker with remote access could potentially exploit this vulnerability, leading to Command execution. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Special Elements used in an OS Command ('OS Command Injection') vulnerability. A low privileged attacker with remote access could potentially exploit this vulnerability, leading to Command execution. |
| Dell OpenManage Enterprise, versions prior to 4.8.0, contains an Improper Neutralization of Special Elements used in an OS Command ('OS Command Injection') vulnerability. A high privileged attacker with remote access could potentially exploit this vulnerability, leading to Command execution. |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Keep the predicate limit separate from program capacity
predicate_parse() adds two to nr_preds to reserve the terminal TRUE
and FALSE entries. It also uses that increased value as the limit for
parsed predicates. If the initial count is smaller than the number
actually parsed, the program can fill the allocation and subsequent
accesses can go past its end.
Keep nr_preds as the predicate limit and use a separate value for the
allocation size. This leaves space for both terminal entries and a
zeroed entry when parsing stops at the limit. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix heap overflow in cifs_do_set_acl()
cifs_set_acl() validates ACL size using posix_acl_xattr_size():
4 + (count * 8) // 4-byte header + 8 bytes per ACE
cifs_do_set_acl() then calls posix_acl_to_cifs() to write the CIFS
wire format into the same buffer:
6 + (count * 10) // 6-byte header + 10 bytes per ACE
An ACL that passes the xattr-based check in cifs_set_acl() can
overflow the heap when posix_acl_to_cifs() writes the larger CIFS
format.
Validate the CIFS format size against the remaining buffer space and
USHRT_MAX before converting--data_count is __u16, so sizes above
USHRT_MAX truncate the on-wire packet length, causing the server to
apply a partial ACL. Replace MaxDataCount = 1000 with
min(CIFSMaxBufSize, USHRT_MAX). |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Check operator stack capacity before pushing
predicate_parse() uses the first operator stack entry before processing
any opening parentheses. A push then increments top before writing.
The existing check still permits that write when top already points to
the last allocated entry, which can access beyond the operator stack.
Reject the push when top reaches the last allocated entry. |
| In the Linux kernel, the following vulnerability has been resolved:
ntfs: fix incorrect MFT record pointer passed to ntfs_attr_record_resize
ntfs_new_attr_flags() passes the wrong MFT record to ntfs_attr_record_resize().
When the attribute is in an extent record, ctx->mrec points to the extent
but the function receives the base record pointer m, causing incorrect
size calculations in memmove.
Fix by passing ctx->mrec (the actual MFT record containing the attribute)
instead of m (the base MFT record) to ntfs_attr_record_resize(). |
| A flaw was found in GCC libstdc++. When an application extracts data into a bitset from a wide-character stream, internal stack memory allocation fails to properly account for character size and alignment. An attacker capable of supplying crafted input to an affected application could trigger a stack-based buffer overflow leading denial of service (DoS). |
| OPNsense before 26.7.8 contains a command injection vulnerability that allows authenticated users with the System: Firmware privilege to execute commands as root by storing a malicious firmware mirror URL. Attackers can submit shell metacharacters through POST /api/core/firmware/set that opnsense-update evaluates with eval, and can also disable package signature verification through sed injection. |
| Improper Neutralization of Special Elements used in a Command ('Command Injection') in the Orchestrator component of SoftIron HyperCloud allows an authenticated user with access to the management plane to execute arbitrary operating system commands on hypervisor hosts as the privileged orchestration user. Attacker-controlled virtual machine template content (for example, the VM DESCRIPTION field) is delivered to hosts through a shell here-document whose terminator is not quoted, so shell expansion and here-document terminator injection are performed on that content during virtual machine lifecycle operations such as deploy, migrate, and network setup. Exploitation requires valid credentials, access to the management plane (owning a virtual machine alone is not sufficient), and a lifecycle operation that reaches the affected host. This issue affects the Orchestrator component of SoftIron HyperCloud from 1.0 through 2.6.17 and is fixed in 2.6.18. |
| DevilutionX 1.4.0 through 1.5.5 contains a heap buffer overflow vulnerability in the bundled libmpq libmpq__archive_dup routine when opening crafted MPQ archives. Attackers can supply an MPQ archive whose block table count exceeds its hash table count, causing memcpy to overflow the heap during startup and crash the game. |
| FLTK through 1.4.5 contains an integer overflow vulnerability in Fl_BMP_Image::load_bmp_() that causes undersized pixel buffer allocation from file-supplied width and height. Attackers can supply a crafted BMP or ICO file with large dimensions so row decoding writes file-derived data past the heap buffer, corrupting the application heap. |
| A vulnerability was identified in Sunwood-ai-labs github-kanban-mcp-server up to 0.4.0. Impacted is the function handleListIssues of the file src/handlers/issue-handlers.ts. Such manipulation of the argument state/labels leads to os command injection. The attack can be launched remotely. Upgrading to version 0.4.1 is recommended to address this issue. The name of the patch is 253d93bbdf7ee9fe42bd8fdf15feea93ae59cbae. It is suggested to upgrade the affected component. |
