| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Dell CloudLink, versions prior to 8.2, contain a vulnerability where a privileged user with known password can run command injection to gain control of system. |
| Adobe Framemaker versions 2020.8, 2022.6 and earlier are affected by a Heap-based Buffer Overflow vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Insufficient control flow management in the Alias Checking Trusted Module (ACTM) firmware for some Intel(R) Xeon(R) processors may allow a privileged user to potentially enable escalation of privilege via local access. |
| Dell PowerProtect Data Manager Reporting, version(s) 19.17, contain(s) an Incorrect Use of Privileged APIs vulnerability. A low privileged attacker with local access could potentially exploit this vulnerability, leading to Elevation of privileges. |
| Improper handling of overlap between protected memory ranges for some Intel(R) Xeon(R) 6 processor with Intel(R) TDX may allow a privileged user to potentially enable escalation of privilege via local access. |
| Memory corruption when using Virtual cdm (Camera Data Mover) to write registers. |
| Memory corruption when programming registers through virtual CDM. |
| Memory corruption while processing IOCTL command when multiple threads are called to map/unmap buffer concurrently. |
| Memory corruption occurs while connecting a STA to an AP and initiating an ADD TS request from the AP to establish a TSpec session. |
| In Modem, there is a possible out of bounds write due to an incorrect bounds check. This could lead to remote escalation of privilege, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01672598; Issue ID: MSV-4622. |
| In ims service, there is a possible out of bounds write due to a missing bounds check. This could lead to remote escalation of privilege, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01671924; Issue ID: MSV-4620. |
| A vulnerability in the Cisco Industrial Ethernet Switch Device Manager (DM) of Cisco IOS Software could allow an authenticated, remote attacker to elevate privileges.
This vulnerability is due to insufficient validation of authorizations for authenticated users. An attacker could exploit this vulnerability by sending a crafted HTTP request to an affected device. A successful exploit could allow the attacker to elevate privileges to privilege level 15.
To exploit this vulnerability, the attacker must have valid credentials for a user account with privilege level 5 or higher. Read-only DM users are assigned privilege level 5. |
| A potential security vulnerability has been identified in the HP Touchpoint Analytics Service for certain HP PC products with versions prior to 4.2.2439. This vulnerability could potentially allow a local attacker to escalate privileges. HP is providing software updates to mitigate this potential vulnerability. |
| A vulnerability exists in NGINX Ingress Controller's nginx.org/rewrite-target annotation validation.
Note: Software versions which have reached End of Technical Support (EoTS) are not evaluated. |
| Improper Restriction of XML External Entity Reference vulnerability in Apache Camel XPath component.
This issue affects Apache Camel: from 4.0.0 before 4.18.5, from 4.19.0 before 4.22.1.
With documentType set to InputSource, XPathBuilder handed the payload straight to javax.xml.xpath, which builds a DocumentBuilder of its own using the JDK defaults. The hardening applied to Camel's default document type was therefore bypassed: a DOCTYPE declaration that is refused on the default type was accepted here, and the external entity it declared was resolved and expanded into the evaluated document. An external sender whose XML reaches such an expression could read files readable by the Camel process and cause the process to issue requests to hosts it names. The two document types disagreeing on parser configuration is what made this reachable, since a deployment choosing InputSource for streaming reasons had no indication it was also choosing a weaker parser.
Upgrade to Apache Camel 4.23.0, which fixes the issue. Users on the 4.18.x LTS releases stream should upgrade to 4.18.5. Users on the 4.22.x LTS releases stream should upgrade to 4.22.1. The InputSource document type now goes through the same hardened parser as the default type, so a DOCTYPE is refused. Note that it also shares that type's documented escape hatch: the same DocumentBuilderFactory system properties that relax the default type relax this one, so a deployment that has set them remains unprotected by design. For deployments that cannot upgrade immediately, do not use documentType=InputSource on expressions evaluated over untrusted XML; the default document type already refuses a DOCTYPE. |
| Exposure of Sensitive Information to an Unauthorized Actor vulnerability in Apache Camel HTTP component.
This issue affects Apache Camel: from 4.0.0 before 4.18.5, from 4.19.0 before 4.22.1.
Two paths handed credentials to a redirect target, which is a host chosen by the remote server rather than by the route, once followRedirects=true. OAuth2ClientConfigurer registers its interceptor with addRequestInterceptorFirst, and HttpClient runs protocol-level request interceptors inside ProtocolExec, which sits below RedirectExec in the exec chain; the interceptor therefore ran again for every redirect hop and re-attached Authorization: Bearer to whatever host the Location header named. Separately, credentials were registered against an AuthScope matching any host, so basic and digest credentials were presented to a redirect target as well. A remote endpoint - or anyone who can influence its responses - could therefore collect the bearer token or the configured credentials simply by answering with a redirect to a host it controls.
Upgrade to Apache Camel 4.23.0, which fixes the issue. Users on the 4.18.x LTS releases stream should upgrade to 4.18.5. Users on the 4.22.x LTS releases stream should upgrade to 4.22.1. Credentials are now sent only to the authority the endpoint was configured with, and are not re-attached when a redirect crosses to another host. For deployments that cannot upgrade immediately, set followRedirects=false on endpoints that carry credentials, and handle any redirect explicitly in the route so that the destination is chosen by the route rather than by the remote server. |
| Deserialization of Untrusted Data vulnerability in Apache Camel Camel-Jgroups component.
This issue affects Apache Camel: from 4.0.0 before 4.18.5, from 4.19.0 before 4.22.1.
JGroupsEndpoint.createExchange(Message), which CamelJGroupsReceiver calls for every message the jgroups consumer receives before the exchange is routed, set the exchange body from org.jgroups.Message.getObject(). For an ObjectMessage, which is the message type the Camel jgroups producer sends, JGroups Java-deserializes the payload through an ObjectInputStream on its own receive thread as the message arrives, and getObject() returns the resulting object. No java.io.ObjectInputFilter was applied on that path unless the deployment had set a JVM-wide serialization filter: camel-jgroups installed none, and the JGroups versions shipped with the affected releases apply none of their own, so any serializable class on the application classpath could be instantiated and its deserialization callbacks run. Unless a channel or the channelProperties option is configured, the consumer creates its channel with new JChannel(), the stock JGroups protocol stack, which multicasts over UDP without the AUTH protocol and without encryption, so any host able to reach the cluster's multicast group or bind port can join the cluster and send messages to the consumer without credentials. Such a host could send a crafted serialized object that leads to remote code execution in the Camel process when a usable deserialization gadget chain is present on the classpath, and no non-default option was required on the consumer. Because JGroups materializes the object before Camel's receiver runs, a check performed by Camel can only inspect the deserialized result and cannot stop code that runs during deserialization, so closing the issue also requires a control that applies before the payload is read, as described in the mitigation. Exploitation requires network access to the cluster's multicast group or bind port, which with the default UDP multicast transport means a host on an adjacent network, and a usable gadget chain on the classpath, which is why the severity is assessed as high rather than critical.
Users are recommended to upgrade to version 4.23.0, which fixes the issue. If users are on the 4.22.x releases stream, then they are suggested to upgrade to 4.22.1. If users are on the 4.18.x releases stream, then they are suggested to upgrade to 4.18.5. The 4.14.x releases stream and earlier, and the 4.15.x to 4.17.x and 4.19.x to 4.21.x release lines, reached end of life before this issue was resolved and will not receive a fix, so deployments on those lines must move to a supported release. |
| Vulnerability in the PeopleSoft Enterprise PeopleTools product of Oracle PeopleSoft (component: Integration Broker). Supported versions that are affected are 8.61-8.63. Easily exploitable vulnerability allows low privileged attacker with network access via HTTP to compromise PeopleSoft Enterprise PeopleTools. While the vulnerability is in PeopleSoft Enterprise PeopleTools, attacks may significantly impact additional products (scope change). Successful attacks of this vulnerability can result in unauthorized creation, deletion or modification access to critical data or all PeopleSoft Enterprise PeopleTools accessible data. CVSS 3.1 Base Score 7.7 (Integrity impacts). CVSS Vector: (CVSS:3.1/AV:N/AC:L/PR:L/UI:N/S:C/C:N/I:H/A:N). |
| An out-of-bounds read was addressed with improved bounds checking. This issue is fixed in macOS Golden Gate 27.2, macOS Sequoia 15.8.2, macOS Tahoe 26.7.2. An app may be able to cause unexpected system termination or read kernel memory. |
| Use after free in Bookmarks in Google Chrome prior to 156.0.8078.47 allowed a remote attacker to execute arbitrary code outside the sandbox via a crafted Chrome extension. (Chromium security severity: Low) |
