| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
xfs: fix wild memcpy access when formatting ondisk rtrefcount btree roots
LOLLM noticed that the inode btree root formatting methods copy too many
bytes -- there's only one set of keys in node blocks, not two. This
causes memory corruption of whatever's beyond the buffers. |
| A vulnerability was identified in Tencent ncnn up to 44b02dabdcf97499281a4692ebd65bad73dcf8b6. Affected by this vulnerability is the function matmul_transb of the file src/layer/matmul.cpp of the component MatMul. The manipulation leads to out-of-bounds read. The attack can be initiated remotely. The exploit is publicly available and might be used. The project was informed of the problem early through an issue report but has not responded yet. |
| An output escaping vulnerability in the Audit Logs component of Crafty Controller allows a remote, unauthenticated attacker to perform stored cross-site scripting via HTTP header injection |
| OPNsense is a FreeBSD based firewall and routing platform. Prior to version 26.1.11, the unauthenticated WebGUI login usernamefld accepts carriage-return and line-feed characters that survive LOG_AUTH processing through syslog-ng-lockout.conf into the syslog-ng program destination feeding lockout_handler. The consumer's readline() processing treats an injected fragment as a separate authentication event and selects the first syntactically valid IP address from the forged line. An attacker with network access to the login page can forge failure events for another IP, causing that IP to be added to the sshlockout PF table and its active states to be killed, or forge accepted events that reset an attacker's own brute-force counter. This can block administrative, DNS, gateway, or monitoring addresses and can bypass password-guessing lockout without authentication. This issue is fixed in version 26.1.11. |
| Incorrect boundary conditions in the JavaScript Engine component. This vulnerability was fixed in Firefox 158, Firefox ESR 115.43, Firefox ESR 153.5, Thunderbird 158, and Thunderbird 153.5. |
| Incorrect boundary conditions in the JavaScript Engine component. This vulnerability was fixed in Firefox 158, Firefox ESR 115.43, Firefox ESR 153.5, Thunderbird 158, and Thunderbird 153.5. |
| Incorrect boundary conditions in the Layout component. This vulnerability was fixed in Firefox 158 and Thunderbird 158. |
| Improper neutralization of special elements in the NetBird client SSH configuration manager (client/ssh/config/manager.go) in NetBird versions 0.60.0 through 0.74.6 allows a malicious or compromised peer to execute arbitrary commands on other NetBird client hosts. The client writes a system-wide OpenSSH drop-in file (/etc/ssh/ssh_config.d/99-netbird.conf, or the equivalent under %PROGRAMDATA%\ssh\ssh_config.d on Windows) that embeds each peer FQDN or hostname inside a double-quoted Match host directive without escaping. A peer name containing a double quote breaks out of the quoted context and injects arbitrary SSH configuration directives, including exec commands, which run locally as any user on the host the next time that user runs ssh. Desktop clients on Linux, macOS, Windows and FreeBSD are affected; the Android and iOS apps are not. The issue is fixed in version 0.74.7, which accepts a peer FQDN or hostname only if it is a valid DNS name. |
| cpp-httplib is a C++ header-only HTTP/HTTPS library. From 0.29.0 until 0.51.0, Client::open_stream in httplib.h accepts a caller-controlled path that reaches detail::write_request_line() without the detail::encode_path() protection used by the ordinary buffered request path. Raw carriage-return and line-feed bytes in the path can therefore split the outbound HTTP/1.1 request line and inject attacker-shaped request metadata. Exploitation requires an embedding application to pass remote user input into the open_stream path and a backend or intermediary that interprets the injected bytes; the established impact is modification of backend-visible request data, not direct confidentiality or availability impact. This issue is fixed in version 0.51.0. |
| MCP Context Forge is an MCP gateway and administrative platform. Prior to 1.0.2, mcpgateway/config.py and .env.example ship a known JWT_SECRET_KEY, while verify_jwt_token() accepts HS256 tokens signed with that key and get_current_user() creates a platform administrator when the token subject matches PLATFORM_ADMIN_EMAIL and REQUIRE_USER_IN_DB is false. A remote unauthenticated attacker can therefore mint accepted administrator tokens without a database account. While the vulnerable signing key remains configured and the platform-admin bootstrap remains enabled, forged access survives password rotation, account deletion, and session revocation, allowing administrative disclosure, modification, and service disruption. This issue is fixed in version 1.0.2. |
| In the Linux kernel, the following vulnerability has been resolved:
net: remove CAP_SYS_RAWIO zero-padding in dev_validate_header
dev_validate_header() reads dev->hard_header_len directly when
zero-padding short link layer headers for CAP_SYS_RAWIO holders:
if (capable(CAP_SYS_RAWIO)) {
memset(ll_header + len, 0, dev->hard_header_len - len);
return true;
}
Packet send paths call dev_validate_header() on skbs whose headroom was
allocated from an earlier hard_header_len read. If the device is
reconfigured so that dev->hard_header_len increases before validation,
the memset writes past the reserved buffer, an out-of-bounds write.
This out-of-bounds write is masked in some SOCK_RAW paths today because
the same concurrent increase can first make skb_push() exceed the
reserved headroom and trigger skb_under_panic(). Remove the zero-padding
branch before making those hard_header_len reads consistent, so the
snapshot fixes do not turn a loud panic into a silent overwrite.
This path is only reached for variable length L2 protocols, where
len < hard_header_len but len >= min_header_len. No remaining in-tree
variable length L2 protocol implements header_ops->validate, and the
CAP_SYS_RAWIO bypass that zero-pads and accepts short headers has no
real value beyond allowing testing of intentionally malformed input.
Drop the CAP_SYS_RAWIO branch. The remaining reads of
dev->hard_header_len in dev_validate_header() are comparisons only and
have no memory safety impact. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: validate individual TWT params before driver setup
ieee80211_process_rx_twt_action() only partially validates a received
S1G TWT setup frame before queueing it.
An individual agreement can therefore reach ieee80211_s1g_rx_twt_setup()
with twt->length too short for the full struct ieee80211_twt_params.
The individual path passes twt to drv_add_twt_setup(). Both the tracepoint
and the driver callback consume the complete parameters block, not merely
req_type. Do not pass a short individual agreement to the driver.
Broadcast agreements remain unchanged because they are rejected locally
after accessing only req_type.
[edit commit message to not overclaim lack of validation nor
understate driver impact] |
| In the Linux kernel, the following vulnerability has been resolved:
drm/vmwgfx: fix guest_memory_dirty bitfield clobbered as size
Two sites in vmwgfx_resource.c assign boolean literals to
res->guest_memory_size, which is an unsigned long allocation-size
field; the intended target is the adjacent res->guest_memory_dirty
bitfield. After the assignments the field holds 0 or 1 instead of
the resource's MOB allocation size:
- vmw_resource_release() writes 0 (false), and
- vmw_resource_unbind_list() writes 1 (true).
Subsequent revalidation paths read guest_memory_size when computing
the dirty page range (vmw_bo_dirty_transfer_to_res()) and the buffer
allocation size (vmw_resource_buf_alloc()), producing zero-length
walks or wrap-around ranges that read or write past the MOB bitmap.
The dirty-tracking intent of the original code (mark the resource as
dirtied since the last sync) is also lost, since guest_memory_dirty
is never updated.
Rename both assignments to guest_memory_dirty. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: bound mode sysfs output to the sysfs buffer
mode_string() uses snprintf() which can return a value larger than the
remaining buffer space. show_modes() accumulates the return value into i
without checking whether i has reached PAGE_SIZE, causing the offset to
advance past the sysfs buffer if the modelist is long enough.
Add a size parameter to mode_string() and use scnprintf() to return
only the bytes actually written. Add an early return when offset
already exceeds the buffer. In show_modes(), stop accumulating once
the buffer is full. |
| In the Linux kernel, the following vulnerability has been resolved:
ipvs: avoid out-of-bounds write in ip_vs_nat_icmp
Sashiko warns that local attacker can modify the packet
while it is processed by IPVS. Some places read the
IP ihl field multiple times which can cause out-of-bounds
access. One such place is ip_vs_nat_icmp where we
can write after the validated area.
Fix it by providing ciph argument just like it is done for
IPv6 and use ciph->len as offset to the embedded transport
header.
Modify some IPv4 header checks by reading the ihl field
only once. |
| In the Linux kernel, the following vulnerability has been resolved:
sctp: prevent peer transport count overflow
sctp_assoc_add_peer() increments the association's 16-bit transport_count
for every new unique peer. Adding the 65,536th transport wraps the count to
zero.
SCTP sock_diag uses transport_count to reserve the INET_DIAG_PEERS payload,
then copies one sockaddr_storage for every entry in transport_addr_list.
After the wrap, a diagnostic dump reserves an empty payload and writes
8 MiB of peer addresses past the skb tail.
Reject a new unique peer when transport_count has reached U16_MAX. Perform
the check after the existing-peer lookup so a duplicate address continues
to return its existing transport at the limit. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: ath9k: fix OOB access from firmware tx status queue ID
ath_tx_edma_tasklet() accesses sc->tx.txq[ts.qid] where ts.qid is a
4-bit hardware field (0-15), but the txq array only has
ATH9K_NUM_TX_QUEUES (10) entries. A qid >= 10 causes an OOB array
access.
Add a bounds check on ts.qid before using it as an array index. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: ccp - Fix snp_filter_reserved_mem_regions() off-by-one
Sashiko notes:
> regarding the bounds check in snp_filter_reserved_mem_regions()
> called via walk_iomem_res_desc(): does the check
> if ((range_list->num_elements * 16 + 8) > PAGE_SIZE)
> allow an off-by-one heap buffer overflow?
>
> If range_list->num_elements is 255, 255 * 16 + 8 = 4088, which is <= 4096.
> Writing range->base (8 bytes) fills 4088-4095, but writing range->page_count
> (4 bytes) would write to 4096-4099, overflowing the kzalloc-allocated
> PAGE_SIZE buffer.
Fix this by accounting for the entry about to be written to, in addition to
the entries that are already allocated. |
| During Xenstore live update the state record for a Xenstore watch with
specified watch depth is written with two bytes missing. This results
in an inconsistent state when reading the state back in the new Xenstore,
causing a crash of Xenstore or wrong Xenstore data. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: meson: aiu: Validate written enum values
The AIU HDMI and internal codec mux put callbacks use the written enum
value with snd_soc_enum_item_to_val() before checking whether the value is
valid for the enumeration.
Reject out-of-range values before converting the enum item, matching the
validation already done by the G12A HDMI and internal codec mux controls. |
